Compound KLT-30
Compounds are produced from new low molecular weight rubber – dimethylsilox.
Compounds KL are paste-like materials, vulcanizing at ambient temperature and moving to the
rubbery state (also for two-component compounds mixing with catalyst).
In the uncured (unvulcanized) state, the compound is a homogeneous paste-like mass of white color.
Compounds "KL" type (TU 38.103691-89) are used for surface sealing of different equipment, operating
in open air and for protection it from moister and high vibration. The compounds possess high
dielectric properties; can glue glass, plexiglass, ceramics and other materials, which are based
on silicones.
KLT-30 is also used for sealing of threaded pipe connections, internal water supply and heating
system.
- Dielectric,
- heat-resistant,
- shakeproof,
- waterproof and water resistant,
- high adhesion, especially to materials based on silicon.
Temperature resistance, oC | -60...+300 |
Lifetime, minutes, no less | 15 |
Conventional strength of |
0.79 |
Relative elongation at a break, % min | 120 |
Volume electrical resistance at the temperature (20±5)oC and relative air humidity (65±5)%, Ohm x cm |
1x10 13 |
Tangent of dielectric loss at frequency 10 6 Hz, max |
0.01 |
Full curing time not less than, hours |
24 |
Packaging: One-component compounds KLT-30 Two-component compounds KLT-30 |
aluminum tubes; Part A - 40 liters in drums, Part B (catalyst) – glass bottles |
Shelf life KLT-30 – 6 months.